User Manual

no wireless-device-watch interval
[Parameter]
time : <10-86400>
Acquisition interval (seconds)
[Initial value]
wireless-device-watch interval 60
[Input mode]
L2MS mode
[Description]
Specifies the time interval at which device information for a device downstream of a wireless AP is acquired. Information for
the devices existing downstream the wireless AP is acquired when the time specified by time has elapsed.
[Note]
If device watch is not operating, device information is not acquired, regardless of the setting of this function.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
Set the device information acquisition time interval to 3,600 seconds.
SWP1(config)#l2ms configuration
SWP1(config-l2ms)# wireless-device-watch interval 3600
4.9 Firmware update
4.9.1 Set firmware update site
[Syntax]
firmware-update url url
no firmware-update url
[Parameter]
url : Single-byte alphanumeric characters and single-byte symbols (255 characters or less)
URL at which the firmware is located
[Initial value]
firmware-update url http://www.rtpro.yamaha.co.jp/firmware/revision-up/swp1.bin
[Input mode]
global configuration mode
[Description]
Specify the download source URL used when updating the firmware from a firmware file located on a web server.
The input syntax is "http://server IP address or hostname/pathname".
If the server's port number is other than 80, you must specify this within the URL, using the syntax "http://server IP address or
hostname:port number/path name".
[Example]
Specify http://192.168.100.1/swp1.bin as the firmware download URL.
SWP1(config)#firmware-update url http://192.168.100.1/swp1.bin
SWP1(config)#
4.9.2 Execute firmware update
[Syntax]
firmware-update execute [no-confirm]
[Keyword]
no-confirm : Don't confirm the firmware update
50 | Command Reference |
Maintenance and operation functions