User Manual

4.8 L2MS (Layer 2 management service) settings
4.8.1 Move to L2MS mode
[Syntax]
l2ms configuration
[Input mode]
global configuration mode
[Description]
Moves to L2MS mode in order to make L2MS settings.
[Note]
To return from L2MS mode to global configuration mode, use the exit command. To return to priviledged EXEC mode, use the
end command.
[Example]
Move to L2MS mode.
SWP1(config)#l2ms configuration
SWP1(config-l2ms)#
4.8.2 Set slave watch interval
[Syntax]
slave-watch interval time
no slave-watch interval
[Parameter]
time : <2-10>
Watch interval (seconds)
[Initial value]
slave-watch interval 3
[Input mode]
L2MS mode
[Description]
Specifies the time interval at which to transmit a slave query frame.
If this command is executed with the "no" syntax, the setting returns to the default.
If you set time to a high value, the query frame is transmitted less often, but it will take longer from when the slave is connected
until the controller recognizes it. If you set time to a low value, the opposite will be the case; the query frame is transmitted
more often, but it will take less time from when the slave is connected until the controller recognizes it.
[Note]
Slave watch is performed only if L2MS is operating as controller.
[Example]
Set the watch interval to five seconds.
SWP1(config)#l2ms configuration
SWP1(config-l2ms)#slave-watch interval 5
4.8.3 Set number of times that is interpreted as slave down
[Syntax]
slave-watch down-count count
no slave-watch down-count
[Parameter]
count : <2-10>
Number of times that is interpreted as down
46 | Command Reference | Maintenance and operation functions