User Manual

SWP1#write
Building configuration...
[OK]
SWP1#
4.2.3 Save certain functions to the backup configuration
[Syntax]
backup-config
[Input mode]
priviledged EXEC mode
[Description]
Saves the settings of certain functions to the backup configuration.
This applies to the following functions.
• Settings related to IPv4 addresses
•
Settings related to time zone and NTP
• Administrator password setting
• Settings related to firmware updating
• Settings related to SYSLOG
• Settings related to HTTP server functions
• Settings related to Telnet server functions
• Settings for the load balance function
[Note]
This command can be used only when the configuration mode of the SWP1 is DANTE mode.
If a backup configuration exists when the SWP1 starts in DANTE mode, those settings are restored to the running
configuration.
The erase startup-config command can be used to delete the saved backup configuration.
[Example]
Save the settings of the applicable functions to the backup configuration.
SWP1#backup-config
4.2.4 Show the running configuration
[Syntax]
show running-config [
section]
[Parameter]
section : Section to be shown
Setting value Description
access-list Access list related
igmp IGMP related
interface Interface related
ip IP related
ipv6 IPv6 related
l2ms L2MS related
mld MLD related
mstp MSTP related
snmp SNMP related
switch LACP, VLAN related
telnet-server TELNET server related
Command Reference | Maintenance and operation functions | 31