User Manual

Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON4 Enable - Access 2 - ✓
etherCON5 Disable - Access 1(default) - ✓
etherCON6 Disable - Access 1(default) - ✓
etherCON7 Enable - Access 2 - ✓
etherCON8 Enable - Access 2 - ✓
opticalCON9 Disable - Access 1(default) - ✓
opticalCON10 Enable - Access 2 - ✓
• SWP1-8/8MMF's VLAN preset C settings (VLAN interface)
• VLAN #1(for Primary Dante and Control)
•
IPv4 Address : DHCP
• IGMP Snooping : Enable
• Querier : Enable
• Query Interval : 30sec
• Fast-Leave : Disable
• Check TTL : Disable
• VLAN #2(for Secondary Dante and Control)
• IGMP Snooping : Enable
• Querier : Enable
• Query Interval : 30sec
• Fast-Leave : Disable
• Check TTL : Disable
• SWP1-16MMF's VLAN preset Normal settings (LAN/SFP port)
Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON1 Disable - Access 1(default) - ✓
etherCON2 Disable - Access 1(default) - ✓
etherCON3 Disable - Access 1(default) - ✓
etherCON4 Disable - Access 1(default) - ✓
etherCON5 Disable - Access 1(default) - ✓
etherCON6 Disable - Access 1(default) - ✓
etherCON7 Disable - Access 1(default) - ✓
etherCON8 Disable - Access 1(default) - ✓
RJ45 9 Disable - Access 1(default) - ✓
RJ45 10 Disable - Access 1(default) - ✓
RJ45 11 Disable - Access 1(default) - ✓
RJ45 12 Disable - Access 1(default) - ✓
etherCON13 Disable - Access 1(default) - ✓
etherCON14 Disable - Access 1(default) - ✓
etherCON15 Disable - Access 1(default) - ✓
etherCON16 Disable - Access 1(default) - ✓
opticalCON17 Disable
sa1 Access 1(default) ✓ -
opticalCON18 Disable
• SWP1-16MMF's VLAN preset Normal settings (VLAN interface)
• VLAN #1(for Dante and Control)
• IPv4 Address : DHCP
24 | Command Reference | Configuration