User Manual

Category Setting item Setting value
Flow control (IEEE 802.3x) threshold
value
Start control: 80%, Return from
control: 60%
• Settings common to all models and presets (LAN/SFP port)
Category Setting item Setting value
Basic settings
Speed/duplex mode setting auto
Cross/straight automatic detection enabled
MRU 1,522 Byte
Port description none
EEE disabled
L2MS L2MS filter depends on preset
L2 switching
Spanning tree depends on preset
Proprietary loop detection depends on preset
Traffic control
QoS trust mode DSCP
Flow control (IEEE 802.3x) disabled
Storm control disabled
• SWP1-8/8MMF's VLAN preset Normal settings (LAN/SFP port)
Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON1 Disable - Access 1(default) - ✓
etherCON2 Disable - Access 1(default) - ✓
etherCON3 Disable - Access 1(default) - ✓
etherCON4 Disable - Access 1(default) - ✓
etherCON5 Disable - Access 1(default) - ✓
etherCON6 Disable - Access 1(default) - ✓
etherCON7 Disable - Access 1(default) - ✓
etherCON8 Disable - Access 1(default) - ✓
opticalCON9 Disable
sa1 Access 1(default) ✓ -
opticalCON10 Disable
• SWP1-8/8MMF's VLAN preset Normal settings (VLAN interface)
• VLAN #1(for Dante and Control)
•
IPv4 Address : DHCP
• IGMP Snooping : Enable
• Querier : Enable
• Query Interval : 30sec
• Fast-Leave : Disable
• Check TTL : Disable
• SWP1-8/8MMF's VLAN preset A settings (LAN/SFP port)
Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON1 Disable - Access 1(default) - ✓
etherCON2 Disable - Access 1(default) - ✓
etherCON3 Disable - Access 2 - ✓
etherCON4 Disable - Access 2 - ✓
22 | Command Reference | Configuration