User Manual

13.2.33 Set individual policers (single rate)
[Syntax]
police [
single-rate] CIR CBS EBS yellow-action action red-action action
no police
[Keyword]
single-rate : Use single-rate policer
[Parameter]
CIR : <1 - 102300000>
Traffic rate (kbps)
CBS : <11 - 2097120>
Burst size of conformant token bucket (kbyte)
EBS : <11 - 2097120>
Burst size of excess token bucket (kbyte)
action : Operation for packets categorized by bandwidth class
Setting value Operation
transmit Forward
drop Discard
remark Remarking (CoS/TOS/DSCP)
[Input mode]
policy map class mode
[Description]
Specifies individual policers (single rate) for the categorized traffic classes.
If the setting was already made by the police command, its content is changed.
Metering on the SWP1 is implemented as a single-rate three-color marker (RFC2697), and the following processing can be
specified for the categorized bandwidth classes.
• Green : Only forward (cannot be specified)
•
Yellow : Choose forward, discard, or remark
• Red : Choose discard or remark
However, remarking can be specified for either Yellow or Red, not both.
Detailed remarking settings are made using the remark-map command (policy map class mode). Regardless of whether action
is set to "remark," remarking is disabled if there are no detailed remarking settings for that bandwidth class. In this case, the
default settings (Yellow: forward, Red: discard) are applied.
If this is executed with the "no" syntax, metering/policing/remarking processing is deleted.
This cannot be used in conjunction with the aggregate policer (police-aggregate command).
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Make the following settings for received frames of LAN port #1
• Permit traffic from the 10.1.0.0 network
• Categorize bandwidth classes as CIR:48kbps, CBS:12kbyte, and EBS:12kbyte
• Green: forward, Yellow: rewrite DSCP value to 10, Red: discard
[Traffic class definition]
SWP1(config)#ip-access-list 1 permit 10.1.0.0 0.0.255.255
SWP1(config)#class-map class1
SWP1(config-cmap)#match access-group 1
SWP1(config-cmap)#exit
[Policy settings]
202 | Command Reference | Traffic control