User Manual

13.2.29 Show QoS access list
[Syntax]
show qos-access-list acl-id
show qos-access-list name
[Parameter]
acl-id : <1 - 99>
Standard IPv4 access list ID
: <100 - 199>
Extended IPv4 access list ID
: <1300 - 1999>
Standard IPv4 access list ID
: <2000 - 2699>
Extended IPv4 access list ID or MAC access list ID
: <3000 - 3699>
IPv6 access list ID
name : Access list name
[Input mode]
unprivileged EXEC mode、priviledged EXEC mode
[Description]
Show QoS access list information.
If parameters are omitted, all QoS access lists are shown.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Show information for standard IPv4 access list #2.
SWP1#show qos-access-list 2
Standard IP QoS access list: 2
permit 192.168.1.0, wildcard bits 0.0.0.255
permit 192.168.2.0, wildcard bits 0.0.0.255
Show information for all access lists.
SWP1#show qos-access-list
Standard IP QoS access list: 2
permit 192.168.1.0, wildcard bits 0.0.0.255
permit 192.168.2.0, wildcard bits 0.0.0.255
Extended IP QoS access list: 100
permit any 192.168.1.0 0.0.0.255 host 10.1.1.1
permit any 192.168.2.0 0.0.0.255 host 10.1.1.1
MAC QoS access list: 2000
deny 0003.2812.3456 0000.0000.0000 any
deny 0003.2878.9ABC 0000.0000.0000 any
IPv6 QoS access list: 3002
permit 3ffe:506::/32
permit 3ffe:507::/32
13.2.30 Set pre-marking (CoS)
[Syntax]
set cos value
no set cos
Command Reference | Traffic control | 199