User Manual

Section Item Description
Set CoS-Queue Specify egress queue (CoS)
Set IP-DSCP-Queue Change egress queue (DSCP)
Metering/policing/remarking setting
(police/remark-map)
Aggregator-Police Name Name of aggregate policer (only if
specified)
Mode Metering algorithm (SrTCM/TrTCM)
Shown only for SrTCM average rate Traffic rate (kbits/sec)
burst size Burst size of conformant token bucket
(kBytes)
excess burst size Burst size of excess token bucket (kBytes)
Shown only for TrTCM average rate Traffic rate (kbits/sec)
peak rate Peak traffic rate (kbits/sec)
burst size Burst size of conformant token bucket
(kBytes)
peak burst size Burst size of peak token bucket (kBytes)
yellow-action Action for bandwidth class Yellow
(transmit/drop/remark)
red-action ction for bandwidth class Red (drop/
remark)
• Of the various items in the "match" section and the "set" section, only the single item that has been specified for each
section is shown.
• Regardless of the section, the section is not shown if the corresponding command (match
, set, police) has not been
specified.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Show information for class map "class1."
SWP1#show class-map class1
Class-Map Name: class1
Match vlan 10
Set CoS: 4
Police: Mode: SrTCM
average rate (48 Kbits/sec)
burst size (12 KBytes)
excess burst size (12 KBytes)
yellow-action (Remark [CoS:2])
red-action (Drop)
13.2.25 Generate standard IPv4 access list
[Syntax]
ip-access-list list-id action src-info
ip-access-list standard name action src-info
no ip-access-list list-id action src-info
no ip-access-list standard name action src-info
[Parameter]
list-id : <1 - 99>|<1300 - 1999>
Standard IPv4 access list ID
name : Name of access list (Maximum 32 characters; uppercase and lowercase are distinguished. You cannot
specify a text string consisting only of numerals.)
194 | Command Reference |
Traffic control