User Manual

13.2.12 Set DSCP - egress queue ID conversion tabl
[Syntax]
mls qos dscp-queue dscp-value queue-id
no mls qos dscp-queue dscp-value
[Parameter]
dscp-value : <0-63>
DSCP value of the conversion source
queue-id : <0-7>
Egress queue ID corresponding to DSCP value
[Initial value]
See [Note]
[Input mode]
global configuration mode
[Description]
Specifies the values of the DSCP - egress queue ID conversion table that is used to determine the egress queue.
If this command is executed with the "no" syntax, the egress queue ID for the specified DSCP value is returned to the default
setting.
The DSCP - egress queue ID conversion table is used when the trust mode is set to DSCP.
[Note]
In order to execute this command, QoS must be enabled.
The following table shows the default settings of the DSCP - egress queue ID conversion table.
DSCP value Egress queue
0-7 2
8-15 0
16-23 1
24-31 3
32-39 4
40-47 5
48-55 6
56-63 7
[Example]
Assign egress queue #4 to DSCP value "0."
SWP1(config)#mls qos dscp-queue 0 4
Return the egress queue ID of DSCP value "23" to the default value.
SWP1(config)#no mls qos dscp-queue 23
13.2.13 Set port priority order
[Syntax]
mls qos port-priority-queue queue-id
no mls qos port-priority-queue
[Parameter]
queue-id : <0-7>
Egress queue ID assigned to LAN/SFP port
Command Reference | Traffic control | 187