User Manual

DSCP trust mode : Enable
Port-Priority trust mode : Disable
Show the status of class map "class1."
SWP1#show mls qos map-status class class1
class1 status
policy-map association : policy1 (Detached)
edit/erase : Disable
attach limitation
CoS trust mode : Enable
DSCP trust mode : Enable
Port-Priority trust mode : Disable
13.2.11 Set CoS - egress queue ID conversion table
[Syntax]
mls qos cos-queue cos-value queue-id
no mls qos cos-queue
[Parameter]
cos-value : <0-7>
CoS value of conversion source
queue-id : <0-7>
Egress queue ID corresponding to CoS value
[Initial value]
See [Note]
[Input mode]
global configuration mode
[Description]
Specifies the values of the CoS - egress queue ID conversion table that is used to determine the egress queue.
If this command is executed with the "no" syntax, the egress queue ID for the specified CoS value is returned to the default
setting.
The CoS - egress queue ID conversion table is used when the trust mode is set to CoS.
[Note]
In order to execute this command, CoS must be enabled.
The following table shows the default settings of the CoS - egress queue ID conversion table.
CoS value Egress queue
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
[Example]
Assign egress queue #4 to CoS value "0."
SWP1(config)#mls qos cos-queue 0 4
Return the egress queue ID of CoS value "0" to the default value.
SWP1(config)#no mls qos cos-queue 0
186 | Command Reference | Traffic control