User Manual

13.2.8 Show egress queue usage ratio
[Syntax]
show mls qos queue-counters [ifname]
[Parameter]
ifname : Name of the LAN/SFP port. If this is omitted, the command applies to all ports.
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the usage ratio for each egress queue of the specified LAN/SFP port. The queue usage ratio is calculated as follows.
(queue usage ratio) = (number of buffers held in the queue) / (maximum length of the queue)
[Note]
This command can be used regardless of the QoS status (enabled/disabled).
[Example]
Show the queue usage ratio of LAN port #1.
SWP1#show mls qos queue-counters ge1
QoS: Enable
Interface ge1 Queue Counters:
Queue 0 59.4 %
Queue 1 15.0 %
Queue 2 0.0 %
Queue 3 0.0 %
Queue 4 0.0 %
Queue 5 3.6 %
Queue 6 0.0 %
Queue 7 0.1 %
13.2.9 Show policy map information
[Syntax]
show policy-map [name]
[Parameter]
name : Policy map name. If this is omitted, all policy map information is shown.
[Input mode]
unprivileged EXEC mode、priviledged EXEC mode
[Description]
Shows information for the specified policy map. The following content is shown.
Item Description
Policy-Map Name Policy map name
State Application status of the policy map (attached/detached)
Class-Map Name Class map information. For details, refer to the show class-
map command.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Show information for policy map "policy1."
SWP1#show policy-map policy1
Policy-Map Name: policy1
State: attached
184 | Command Reference | Traffic control