User Manual

Trust mode Command Restrictions
police, remark-map Cannot use a combination for which
remarking is enabled (*1)
*1) A combination for which remarking is enabled refers to when the yellow-action or red-action of the police command is set
to "remark" and the remark-map of the corresponding color is specified.
[Example]
Apply policy map "policy1" to LAN port #1.
SWP1(config)#interface ge1
SWP1(config-if)#service-policy input policy1
Remove policy map "policy1" from LAN port #1.
SWP1(config)#interface ge1
SWP1(config-if)#no service-policy input policy1
13.2.6 Show status of QoS function setting
[Syntax]
show mls qos
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the enabled (Enable) or disabled (Disable) status of the QoS function.
[Example]
Show the status of the system's QoS setting.
SWP1#show mls qos
Enable
13.2.7 Show QoS information for LAN/SFP port
[Syntax]
show mls qos interface [ifname]
[Parameter]
ifname : Name of the LAN/SFP port. If this is omitted, the command applies to all ports.
Interface to show
[Input mode]
unprivileged EXEC mode、priviledged EXEC mode
[Description]
Shows QoS settings for the specified LAN/SFP port. The following content is shown.
Item Description
Port Trust Mode Trust mode of LAN/SFP port (CoS/DSCP/Port-Priority)
Input Policy-Map Name Name of policy map already applied to the LAN/SFP port and
class map information (note 1)
Port Default CoS Priority Default CoS value (note 2)
Port-Priority-Queue Port priority order (note 3)
Egress Traffic Shaping Traffic shaping (individual port)
Egress Traffic Queue Shaping Traffic shaping (individual queue)
Queue Scheduling Egress queue scheduling format and weight
CoS (Queue) CoS - egress queue ID conversion table (note 2)
DSCP (Queue) DSCP - egress queue ID conversion table (note 4)
182 | Command Reference | Traffic control