User Manual

13.2.2 Set default CoS
[Syntax]
mls qos cos value
no mls qos cos
[Parameter]
value : <0-7>
Default CoS value
[Initial value]
mls qos cos 0
[Input mode]
interface mode
[Description]
Sets the default CoS.
If this command is executed with the "no" syntax, the default value (CoS=0) is specified.
The default CoS is used if untagged frames are received when the port's trust mode is set to CoS. (Since CoS is not specified for
the frame)
[Note]
In order to execute this command, CoS must be enabled.
If this is executed for a port whose trust mode is DSCP, the command results in an execution error.
[Example]
Set the default CoS value to 2.
SWP1(config-if)#mls qos cos 2
Return the default CoS value to the default value.
SWP1(config-if)#no mls qos cos
13.2.3 Set trust mode
[Syntax]
mls qos trust mode
no mls qos trust
[Parameter]
mode : Trust mode
Setting value Description
cos
Determines the egress queue based on the CoS
value
dscp
Determines the egress queue based on the DSCP
value
port-priority
Applies the specified priority to the receiving
port
[Initial value]
mls qos trust cos
[Input mode]
interface mode
[Description]
pecifies the trust mode of the LAN/SFP port.
If this command is executed with the "no" syntax, the default value (CoS trust mode) is specified.
Command Reference | Traffic control | 179