User Manual

The basic commands related to moving between command input modes are described below. For commands that move from
global configuration mode to individual configuration mode, refer to "individual configuration mode."
• exit command
• logout command
• enable command
• disable command
• configure terminal command
• end command
2.4.2 individual configuration mode
individual configuration mode is the overall name for the mode in which you can make detailed settings for specific items such
as LAN/SFP port, VLAN interface, and QoS. To enter individual configuration mode, issue the command for transitioning to
the respective mode from global configuration mode.
On SWP1, individual configuration mode contains the following modes. Some of the modes within individual configuration
mode have a hierarchy. For example, policy map mode → policy map class mode.
individual configuration mode Transition command Prompt
interface mode interface command SWP1(config-if)#
line mode line console command
line vty command
SWP1(config-line)#
VLAN mode vlan database command SWP1(config-vlan)#
VLAN access map mode vlan access-map command SWP1(config-vlan-access-map)#
MST mode
spanning-tree mst configuration
command
SWP1(config-mst)#
class map mode class-map command SWP1(config-cmap)#
policy map mode policy-map command SWP1(config-pmap)#
policy map class mode class command SWP1(config-pmap-c)#
16 | Command Reference | How to use the commands