User Manual

[Initial value]
mac-address-table acquire
[Input mode]
global configuration mode
[Description]
Enables the MAC address acquisition function.
If this is executed with the "no"syntax, the MAC address acquisition function is disabled.
[Note]
If the MAC address acquisition function is disabled, a dynamic entry is not registered in the MAC address table even if a frame
is received.
[Example]
Enable the MAC address acquisition function.
SWP1(config)#mac-address-table acquire
11.4.2 Set dynamic entry ageing time
[Syntax]
mac-address-table ageing-time time
no mac-address-table ageing-time
[Parameter]
time : <10-634>
Ageing time (seconds)
[Initial value]
mac-address-table ageing-time 300
[Input mode]
global configuration mode
[Description]
Sets the dynamic entry ageing time.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
In some cases, there might be a discrepancy between the time specified by this command and the time until the dynamic entry is
actually deleted from the MAC address table.
[Example]
Set the dynamic entry ageing time to 600 seconds.
SWP1(config)#mac-address-table ageing-time 600
11.4.3 Clear dynamic entry
[Syntax]
clear mac-address-table dynamic
clear mac-address-table dynamic adress mac-addr
clear mac-address-table dynamic vlan vlan-id
clear mac-address-table dynamic interface ifname [instance inst]
[Keyword]
address : Specifies the MAC address
vlan : Specifies the VLAN ID
interface : Specifies the interface
instance : Specifies the MST instance.
Command Reference | L2 switching function | 151