User Manual

SWP1(config)#interface ge1
SWP1(config-if)#no loop-detect blocking
11.3.4 Reset loop detection status
[Syntax]
loop-detect reset
[Input mode]
priviledged EXEC mode
[Description]
Resets the loop detection status of all interfaces.
[Note]
This command can be executed only if the system-wide loop detection function is enabled.
[Example]
Reset the loop detection status.
SWP1#loop-detect reset
11.3.5 Show loop detection function status
[Syntax]
show loop-detect
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the settings and status of the loop detection function.
The following items are shown.
• Setting of the system-wide loop detection function
•
Loop detection status for each LAN/SFP port
• Interface name (port)
• Setting of the loop detection function (loop-detect) for LAN/SFP port. If the loop detection function is operating, (*) is
added
• Status of the Port Blocking setting (port-blocking)
• Loop detection status (status)
[Example]
Shows the loop detection status.
SWP1>show loop-detect
loop-detect: Enable
port loop-detect port-blocking status
-------------------------------------------------------
ge1 enable(*) enable Detected
ge2 enable(*) enable Blocking
ge3 enable(*) enable Normal
ge4 enable(*) enable Normal
ge5 enable(*) disable Normal
ge6 enable(*) enable Normal
ge7 enable(*) enable Shutdown
ge8 disable enable ------
ge9 enable enable Normal
-------------------------------------------------------
(*): Indicates that the feature is enabled.
11.4 FDB (Forwarding Data Base)
11.4.1 Set MAC address acquisition function
[Syntax]
mac-address-table acquire
no mac-address-table acquire
150 | Command Reference | L2 switching function