User Manual

11.1.19 Show VLAN access map filter
[Syntax]
show vlan filter
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Show VLAN access map filter application information.
The following items are shown.
•
Name of the VLAN access map
•
VLAN ID applied to VLAN access map
[Example]
Show VLAN access map filter information.
SWP1>show vlan filter
Vlan Filter VAM001 is applied to vlan 1000
11.2 STP (Spanning Tree Protocol)
11.2.1 Set spanning tree for the system
[Syntax]
spanning-tree shutdown
no spanning-tree shutdown
[Initial value]
no spanning-tree shutdown
[Input mode]
global configuration mode
[Description]
Disables spanning tree for the entire system.
If this is executed with the "no" syntax, spanning tree is enabled for the entire system.
[Note]
The spanning tree function and the loop detection function can be used together on the entire system. Enabling spanning tree
does not set the no loop-detect command.
In order to enable spanning tree, spanning tree must be enabled on the interface in addition to this command.
[Example]
Disable spanning tree for the entire system.
SWP1(config)#spanning-tree shutdown
11.2.2 Set forward delay time
[Syntax]
spanning-tree forward-time time
no spanning-tree forward-time
[Parameter]
time : <4-30>
Forward delay time (seconds)
[Initial value]
spanning-tree forward-time 15
[Input mode]
global configuration mode
[Description]
Sets the forward delay time.
132 | Command Reference | L2 switching function