User Manual

Item Description
Distributing Distributing flag
Defaulted Defaulted flag
Expired Expired flag
[Example]
Shows the status of LACP logical interface.
SWP1#show etherchannel
% Lacp Aggregator: po10
% Load balancing: src-dst-mac
% Member:
ge17
ge19
ge21
ge23
Shows the status of the LAN/SFP ports that make up the LACP logical interface.
SWP1#show etherchannel ge17
Etherchannel ge17
Physical admin key 3
Receive machine state Current
Periodic Transmission machine state Slow periodic
Mux machine state Collecting/Distributing
Selection Selected
Information Actor Partner
LAG 0x8000, 00-a0-de-e0-e0-e0 0x8000, 00-a0-de-11-11-11
Admin Key 0001 0001
Port Priority 32768 32768
Ifindex 17 17
Timeout Long Long
Active 1 1
Synchronized 1 1
Collecting 1 1
Distributing 1 1
Defaulted 0 0
Expired 0 0
Aggregator ID 1000000
10.2.5 Set LACP system priority
[Syntax]
lacp system-priority priority
no lacp system-priority
[Parameter]
priority : <1-65535>
LACP system priority
Lower numbers have higher priority
[Initial value]
lacp system-priority 32768
[Input mode]
global configuration mode
[Description]
Sets the LACP system priority.
If this command is executed with the "no" syntax, the setting returns to the default value.
[Note]
If a LACP logical interface is connected to the other device, the system priorities are compared, and control privilege is given to
the device with the higher priority.
[Example]
Set the LACP system priority to 100.
100 | Command Reference |
LAN/SFP port control