User`s manual

CHAPTER2 DeviceNet Unit

2-3 DeviceNet cable connections

Wire the DeviceNet cable to the accessory DeviceNet plug. Make the wiring connec-

tions by referring to the drawing below or the marks on the plug. Make sure the connec-

tions are correct! When finished wiring the cable to the plug, connect it to the DeviceNet

connector as shown below.

Fig. 2-1 DeviceNet cable wiring

*The 3 pins (shield) on the DeviceNet connector are not wired but this causes no prob-

lems during operation. These pins can be used if the customer wants a more secure

ground connection.

CAUTION

Always cut off the power before making the above connections.

Clamp the cable in place so it will not come loose.

Be sure to put an excessive pulling or weight load on the cable when wiring or

installing.

There are limits on the total cable length and the cable length between stations so

always consult the instruction manual for the master station sequencer (PLC).

MEMO

Set MAC ID and communication speed before connecting the DeviceNet cables.

(See "2-5-2 Setting MAC ID and communication speed".)

DeviceNet connector

DeviceNet cable

Controller

1. V- (black)

2. CAN_L (blue)

3. Shield

4. CAN_H (white)

5. V+ (red)

1 2 3 45

DeviceNet plug

MSTB2, 5/5-STF-5, 08AUM

Phoenix Contact