User`s manual

89
CHAPTER2 CC-Link Unit
(20) Point variable P definition ..................................................... Code 0114
The point variable P is set.
Command option
RWwn+7
RWwn+6 RWwn+5
RWwn+4
RWwn+3 RWwn+2
Point number
Command response
RWrn+7
RWrn+6 RWrn+5 RWrn+4
RWrn+3 RWrn+2
(Details)
Point number: A value of 0 to 999 can be specified.
(Example)
Transmission example 1:
The point variable P is set to 100.
RWwn+7
RWwn+6 RWwn+5 RWwn+4
RWwn+3 RWwn+2
RWwn+1
RWwn
0000
0000 0000
0000
0000 0064
0000 0114
Response example 1:
It is normally ended.
RWrn+7
RWrn+6 RWrn+5 RWrn+4
RWrn+3 RWrn+2
RWrn+1
RWrn
0000
0000 0000
0000
0000 0000
0000 0200
MEMO
MEMO
Since the point variable is prepared to treat the point number as the variable, a value
of 0 to 999 can be specified.
!
CAUTION
Though the content of the point variable is held even if the controller power
supply is turned OFF, the point variable is initialized to 0 if the program is reset
or the execution program switch or other operation which the program reset is
applied.