User`s manual

40
CHAPTER2 CC-Link Unit
Output (Remote
→
Master)
RXn0
RXn1
RXn2
RXn3
RXn4
RXn5
RXn6
RXn7
RXn8
RXn9
RXnA
RXnB
RXnC
RXnD
RXnE
RXnF
RX(n+1)0
RX(n+1)1
RX(n+1)2
RX(n+1)3
RX(n+1)4
RX(n+1)5
RX(n+1)6
to
RX(n+1)F
RX(n+2)0
to
RX(n+2)F
SRV-O
(ZONE0)
(ZONE1)
(ZONE2)
(ZONE3)
ORG-O
END
BUSY
READY
SO200
SO201
SO202
SO203
SO204
SO205
SO206
to
SO215
SO216
to
SO231
SRV-O
(ZONE0)
(ZONE1)
(ZONE2)
(ZONE3)
ORG-O
END
BUSY
READY
PO200
PO201
PO202
PO203
PO204
PO205
SRV-O
(ZONE0)
(ZONE1)
(ZONE2)
(ZONE3)
ORG-O
END
BUSY
READY
PO200
PO201
PO202
PO203
ORG-O/ZONE0
SRV-O/ZONE1
SRV-O
(ZONE0)
(ZONE1)
(ZONE2)
(ZONE3)
ORG-O
END
BUSY
READY
PO200
PO201
PO202
PO203
ORG-O/ZONE0
SRV-O/ZONE1
SRV-O
(ZONE0)
(ZONE1)
(ZONE2)
(ZONE3)
ORG-O
END
BUSY
READY
PO200
PO201
PO202
PO203
PO204
PO205
Cannot
be used.
*1: The PO output format differs depending on the values in the "hundreds" and "thousands" places of the I/O
assignment selection parameter (single-axis controllers: PRM59, dual-axis controllers: PRM26).
*2: Specifies the permissible number of movement points for a point movement command (ABS-PT, INC-PT).
*3: Specifies the permissible number of speed switching points for a point movement command (ABS-PT, INC-PT).
*4: In dual-axis controllers, a desired axis can be specified using SI213 and SI214 when executing I/O dedicated
commands (ABS-PT, INC-PT, ORG-S, and SERVO). In this case, the PRM10 (control axis selection with I/O
command) must first be set to "Valid". The same applies when specifying a control axis for executing JOG
movement commands (JOG+, JOG-).
n: Value determined by station number setting