Network Board User's Manual
Table Of Contents
- INTRODUCTION
- Contents
- CHAPTER1 Cautions To Ensure Safety
- CHAPTER2 Ethernet Unit
- 2-1 Ethernet unit features
- 2-2 How data is exchanged
- 2-3 How to connect to Ethernet
- 2-4 Making system settings for the controller (server)
- 2-5 Making the PC settings (client)
- 2-6 Checking the connection with “ping”
- 2-7 Using TELNET
- 2-8 TELNET dedicated parameters
- 2-9 TELENET communication commands
- 2-10 Making a connection with TELNET.EXE
- 2-11 Other operating tasks
- 2-12 Message List
- 2-13 Troubleshooting
- 2-14 Specifications
- 2-15 Supplement
12
CHAPTER2 Ethernet Unit
2-4-2 Setting the IP address
This following explains how to set the IP address.
The IP address is a number unique to each device and identifies that device from among
many other devices connected on the network. The IP address of one device must not be
the same number as another device so use caution when setting the IP address.
1) Press
F3
(SYS) on the initial menu
screen.
2) Press
F4
(next) to switch the function
display and then press
F2
(OPT).
3) Press
F4
(next) again and then press
F1
(IP).
4) The currently set IP address is now dis-
played. To change it, enter the new IP
address with the number pad keys. (To
move the cursor to right and left between
periods, use the
X
+
Z
or
X
-
Z
keys.)
When completely finished making the
new IP address entry, press the
key.
5) The screen returns to the previous display
in step 4.
[MENU]
select menu
1EDIT2OPRT3SYS 4MON
[SYS]
select menu
1SAFE2OPT 3UTL 4next
[SYS-OPT]
select menu
1IP 2MASK3GWAY4next
[SYS-OPT-IP]
IP address
=
192.168. 0. 2
[SYS-OPT-IP]
IP address
=
133.210.201.100