Specifications
P a g e | 2
SAM1-3GM and SAM1 MADI Combined User Handbook Version One Issue 1
SAFETY
Unless otherwise stated TSL equipment may be installed at any angle or position within an
operating temperature range of 5 - 30C.
All TSL equipment conforms to the EC Low Voltage Directive:
EC Low Voltage Directive (73/23/EEC)(OJ L76 26.3.73)(LVD).
Amendment: (93/68/EEC) (OJ L220 30.8.93).
In all cases the frame of the equipment must be earthed on installation.
Where appropriate, the earth pin on the IEC mains inlet connector is connected to the
metal frame of the equipment, to 0 volts on the internal DC PSU and to signal ground unless
otherwise stated. All metal panels are bonded together.
Check that the voltage selector setting (if fitted) and the fuse rating is correct for the local
mains supply.
Due consideration for cooling requirements must be given when mounting the equipment.
It is recommended that a 1RU of rack space, or a vent panel, should be left above and below the
unit.