manual
En 113
You can configure the system settings of this unit using the front display.
1
Set this unit to standby mode.
2
While holding down STRAIGHT on the font panel, press MAIN ZONE .
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE to set this unit to standby mode and turn it on
again.
The new settings become effective.
ADVANCED SETUP menu items
Changing the speaker impedance setting (SPEAKER IMP.)
Change the speaker impedance settings of unit depending on the impedance of the
speakers connected.
Settings
Configuring the system settings
(ADVANCED SETUP menu)
MAIN ZONE
PROGRAM
STRAIGHT
Item Function Page
SPEAKER IMP. Changes the speaker impedance setting. 113
REMOTE SENSOR
Turns on/off of the remote control sensor on the main
unit.
114
REMOTE CON AMP Selects the remote control ID of the main unit. 114
TUNER FRQ STEP
(Asia and General models only)
Changes the frequency step setting.
114
TV FORMAT Switches the video signal type. 114
MONITOR CHECK Removes the limitation on HDMI video output. 115
RECOV./BACKUP
Creates backup of the settings of this unit, or recovers
the settings from the backup.
115
INITIALIZE Restores the default settings. 115
FIRM UPDATE Updates the firmware. 116
VERSION
Checks the version of firmware currently installed on
this unit.
116
6 Ω MIN
Select this when you connect 6-ohm speakers to this unit. You can also
use 4-ohm speakers as the front speakers.
8 Ω MIN (default) Select this when you connect 8-ohm or higher speakers to this unit.
OUT
1
IN
OUT
2
VOLUME
MUTE
DRCADAPTIVE
3
ZONE
2
SBLPL SBRSB PR
SW1
SL
SW2SW
SR
PL
CL R
PR
STEREO
ENHANCER
SLEEP
HD
TUNED
PRE
AMP
PAR TY
ZONE
3
ZONE
4
HD
TAG
DOCK
8MIN
SPEAKERIMP.
SPIMP.-