Update Manual

5
5. Make sure that the fields in the “File” section indicate as follows:
File name:
RMio64-D_firmXXX.prg
Product name:
RMio64-D
Version: X.XX
• The characters “XXX” and “X.XX”
represent the firmware version number
which will be updated.
• If these fields are empty, click [Select],
and select the “RMio64-
D_firmXXX.prg.”
6. Select the target RMio64-D for updating in “Product name” in the “Connect and
Update” field.
• If this field is empty, your computer
may not be properly connected to the
RMio64-D. Make sure that the cable is
not disconnected or damaged, and that
the program is not blocked by a firewall.
• Each RMio64-D that is operating in
NUAGE system is displayed in gray. To
update the RMio64-D, check NUAGE
Workgroup Manager running on
another computer, and remove the
RMio64-D from the Workgroup.
7. Click [Update].
The progress log and progress bar are displayed on the lower area in “Connect and
Update.”
8. An “Updated successfully” message will be displayed once update is completed, and
the RMio64-D restarts automatically.
After all the RMio64-D updates are completed, check that the firmware version has
been updated.(
→P.2)