Update Manual

■ Updating the Dante firmware

Described below are the procedures to update the Dante module firmware integrated

in the RMio64-D unit.

• To update the Dante firmware, you need to connect an RMio64-D to the computer

one at a time, and repeat the update procedure for each device.

• For details of the Dante Firmware Update Manager, refer to “AUD-MAN-

Firmware Update Manager” stored in the compressed file folder.

1. Connect the Dante [PRIMARY] connector on the rear panel of the RMio64-D unit

to the Ethernet connector on the computer using an Ethernet cable.

Be sure to directly connect the computer and the RMio64-D unit, and do not

connect any other Dante device to the computer.

2. Turn on the power to the RMio64-D.

3. Run the Dante Firmware Update Manager as described below.

Windows

Select [All programs] or [All apps]  [Audinate]  [Dante Firmware Update

Manager]  [Dante Firmware Update Manager], then right-click and select “Run

as Administrator.”

Mac

Double-click “Applications”  “Dante Firmware Update Manager.”

• Confirm in the title bar that the version number is 1.4.7.1 or higher (Windows)

or 1.4.5 or higher (Mac).

• The “User Account Control” dialog box may appear. Click [Continue] or [Yes].

4. If you see the interface selection screen, select the interface card to connect the

Dante device.