User Manual

MultibandEnvelopeShaper
MultibandEnvelopeShaper allows a signal to be split into four frequency bands. You can attenuate or
boost the gain of the attack and release phase of audio material for each band.
Frequency Band Editor
The frequency band editor in the upper half of the panel is where you set the width of the frequency
bands as well as their level. The vertical value scale to the left shows the gain level of each frequency
band. The horizontal scale shows the available frequency range.
• To define the frequency range of the different frequency bands, use the handles at the sides of
each frequency band.
• To attenuate or boost the gain of the frequency band, use the handles at the top of each
frequency band.
LIVE
If this button is activated, the look-ahead feature of the effect is deactivated. Look-
ahead produces more accurate processing, but adds a specific amount of latency as a
trade-off. If [Live] mode is activated, there is no latency, which is better for live
processing.
Bypass Frequency Band
To bypass a frequency band, activate the [Band] button ( ) in each section.
Solo Frequency Band
To solo a frequency band, activate the [S] button on each section. Only one frequency
band can be soloed at a time.
Dynamics Plug-ins
VST Rack Pro Plug-in Reference | 27