User Manual

To copy the settings of a scene to another scene, select the scene that you want to copy, click [Copy],
and click one of the numbered buttons.
You can automate the selection of scenes.
MIX
Sets the level balance between the dry signal and the wet signal.
OUT (-24 to 24 dB)
Sets the output level.
Band Settings
Mute
To mute a frequency band, activate the [M] button in each section.
Bypass Frequency Band
To bypass a frequency band, activate the [Band] button in each section.
Solo Frequency Band
To solo a frequency band, activate the [S] button on each section. Only one frequency band can
be soloed at a time.
[IN/OUT] Meters
Display the input and output level.
GATE
Determines the level at which the gate is activated. Signal levels above the set threshold open
the gate and signal levels below the set threshold close the gate.
TAPE
This band mode simulates the saturation and compression of recording on analog tape machines.
DRIVE
Controls the amount of tape saturation.
TAPE MODE DUAL
Simulates the use of two machines.
TUBE
This band mode simulates the saturation effects using analog tubes.
DRIVE
Controls the amount of tube saturation.
Distortion Plug-ins
VST Rack Pro Plug-in Reference | 9