User Manual

68
5. The registered device is added to the [Device List].
6. Using the same procedure, register all of the target
system’s devices that you want to control.
* A maximum of 20 devices can be registered.
The monitor device is also specified in this screen.
Tap the [Monitor Device] field’s [>] to see a list of the registered
devices.
From this list, select one monitor device to specify it.
* If a monitor device is not specified (No Monitor Device), the page of this app
does not change even if you switch the [Preset] on the device.
Monitor device settings
• Editing information for a registered device
If you tap the icon shown at the right of a registered device
name in the [Device List], you can edit the Unit ID or IP
address and friendly name of that device, or delete its registra-
tion.
When you do so, devices whose parameters are already
assigned to widgets will change as follows.
• Change Unit ID or IP address  Automatically changed to
the new Unit ID or the new IP address.
• Delete registration  Parameter data is cleared.
For the MRX7-D, the [UNIT ID] field shows the Remote Control
Setup List(RCSL), allowing you to change it. When you do so,
the index is carried over without change, but if the newly
loaded index attribute cannot be used by the widget, or if it is
[No Assign], the association is canceled.
If you choose RCSL, the UNIT ID within the file is used to iden-
tify the device.