User Manual
Table Of Contents
- ■ Using the PDF manual
- ■ System Requirements
- ■ Setup
- ■ Operating R Remote
- ■ Uninstalling the software(Removing the application)
- ■ Troubleshooting
R Remote Version 3 User’s Guide 9
Connect the computer and R series units
Use an Ethernet cable to connect the computer and the R series units.
If you selected DAISY CHAIN in “SECONDARY PORT” on the above, connect the Dante connectors of
the R series units in a daisy chain to the computer.
If you selected REDUNDANT in “SECONDARY PORT” on the above, connect the computer to the
network switch that is connected to the Dante [PRIMARY] connector.
Power-on the R series units
Power-on the R series units. If you power-on before making “Settings on the R series units,”
the
settings will not be applied.