User Manual
Table Of Contents
- ■ Using the PDF manual
- ■ System Requirements
- ■ Setup
- ■ Operating R Remote
- ■ Uninstalling the software(Removing the application)
- ■ Troubleshooting
R Remote Version 3 User’s Guide 8
REDUNDANT
(4 down)
・START UP MODE
Settings
Switch
NORMAL
(Start up normally with the settings of the previous start-up.)
(7 and 8 up)
INITIALIZE
(The unit starts up with the internal memory initialized.
Initialization creates the following settings.
・SLOT 1-4 SRC (OFF)
・WORD CLOCK SELECT (DANTE/48kHz)
・USER PATTERN (Same routing configuration as the preset
PATTERN # 1)
・STATIC IP (Manual) (0.0.0.0)
・PANEL LOCK (Unlock)
・Dante PATCH (All OFF)
・Dante DEVICE LABEL (Y001-Yamaha -RSio64-D-123456)
(*1))
(7 down, 8 up)
(*1) The third and fourth characters of the Dante device label depend on device setting DIP switch
1 and the SETUP [UNIT ID] rotary switch. The lower six digits depend on the lower six digits of
the unit’s MAC address.
For RMio64-D
When using R Remote to operate an RMio64-D unit, set the DIP switches and [UNIT ID] rotary switch
of the unit, taking note of the following settings.
Set the DIP switches to the following setting.
・SECONDARY PORT
Settings
Switch
DAISY CHAIN
(1 up)
REDUNDANT
(1 down)