User Manual

R Remote Version 3 User’s Guide 15
Device Selection Area
When you click a display switching button, the corresponding R series unit is shown
in the information display area and in the main area.
With a display switching button selected, pressing the left button makes all
indicators of the corresponding R series unit blink, allowing you to identify the
corresponding unit.
When you right-click a display switching button, the following context menu
appears.
Command
Summary
[Mount]
Opens the "Mount" window. Select the device that you want to mount.
[Connect]
Synchronizes with the selected device.
[Disconnect]
Disconnects from the selected device.
[Properties] Open the “Properties” dialog box.
The connection status is shown below each display switching button.
Indication
Status
VIRTUAL
The device is mounted without the existence of the actual device.
CONNECTING
Currently synchronizing with the device.
CONNECTED
Currently synchronized with the device.
DISCONNECTED
Synchronization with the device is possible, but is currently disconnected by the
[Disconnect] command. Alternatively, communication has been interrupted, or
connection failed.
DUPLICATED
More than one device of the same UNIT ID exists. Eliminate any UNIT ID
conflict between devices.
The VIRTUAL indication is also shown if the device is in any of the following states.
・Device is not powered-on.
・Not connected to the computer.
・Communication is impossible due to incorrect settings.
Information Display Area
This area shows the UNIT ID and name of the selected device.
To check the firmware version or IP address, choose [File] menu -> [Device Information] to open the
"Device Information" dialog box.