User Manual

R Remote Version 2 User’s Guide 10
For Mac
Make TCP/IP settings for the computer as follows.
1. Click [System Preferences]→[Network].
The “Network” dialog box will be displayed.
2. Click the service that you want to connect to the R series unit.
If you're using the Ethernet port that's built into the Mac, click [Ethernet].
3. Make the following settings according to the IP address setting you made in "Settings on the R
series units."
AUTO IP or DHCP STATIC IP (AUTO)
In "Configure IPv4," choose [Using DHCP].
In “Configure IPv4,” choose [Manually]. As the IP
address, enter "192.168.0.xxx (a value in the
range 1 to 254 that does not conflict with any
other device, including the R series units), and
enter "255.255.255.0" as the subnet mask.
The 192.168.0.101 shown below is an example.
If you're using STATIC IP (MANUAL), specify the setting that's appropriate for your network. For
details, consult your network administrator.
4. Click [Apply] button, then close “Network” dialog box.
Use Dante Controller or the CL/QL series console to specify the routing
You'll use Dante Controller or the CL/QL series console to specify the routing.
If you're using Dante Controller to specify the routing, refer to "Dante Controller User’s Guide."
If you're using a CL/QL series console to specify the routing, refer to the each Reference Manual.
This completes the setup.