User Manual

Yamaha Commercial Audio
Dante-MY16-AUD HA Remote Control Guide
11 www.yamahaproaudio.com
Settings by Dante Controller
When you start Dante Controller, the Network View opens first, and all the
Dante equipment on the network appear. This allows you to set the audio
routing between Dante devices. Click a cell in the intersection of transmit and
receive channels to set an audio route from the upper-right transmit channel
to the lower-left receive channel. When the route is set, a green icon appears.
For details, please refer to the Dante Controller user manual.
Double-click a device name of the Dante-MY16-AUD card (communicating an
HA control signal with host equipment) to open the Device View window. On
the HA Remote page, choose Mode 1, Mode 2, or Mode 3 as a serial bridge
mode for HA remote of the Dante-MY16-AUD card. For details about each
mode, please see “Connections for HA Control” (on page 7).
Note:
If the HA Remote page is not displayed on the Device View window, please check
that Dante Controller v3.2.9 or later and the Dante-MY16-AUD firmware v3.3.9 or
later are used.