User Manual

5
1-3 Connecting Speakers
Connect the speakers as illustrated. Connect a subwoofer if needed.
1 Peel back about 10 mm of insulation from the
end of the speaker cable and twist the core
wires tightly.
2 Turn the knob of the speaker jack to the left to
loosen it, and insert the core wires of the
speaker cable into the hole of the jack.
3 Turn the knob back to the right to tighten it.
NOTE
Banana plugs or Y-lugs can also be used. See the User Guide for
details.
ANALOG IN
LINE 1
OPTICAL COAXIAL
USB
LINE 2
GND
2
NETWORK
12V 0.1A
1
L
DIGITAL IN
TRIGGER
OUT
R
CD
LR
PRE OUT
LR
SUBWOOFER
OUT
SPEAKERS R CH
A
B
SPEAKERS L CH
A
B
ANTENNA
FM
75
PHONO
LR
+– –+
Speaker
(Right channel)
Subwoofer (built-in amp)
Speaker
(Left channel)
10 mm
Diameter of hole
for inserting
speaker cable:
6.0 mm
CAUTION
CAUTION is used with information
about potential injuries.
• If the knob of the speaker jack is loosened too far, it will
detach from the product. Be careful if a knob comes off, as a
child may swallow it by accident.
• Do not touch the speaker jacks when this product is On.
Doing so may result in electrical shock.
NOTICE
NOTICE is used with information for preventing
product failure, damage or malfunction.
• If the speaker jacks come in contact with a metal rack, they
may cause a short circuit, resulting in damage to the product.
Leave plenty of space when installing the product so the
speaker jacks do not touch the rack.
• Do not allow the core wires of a speaker cable to touch the
core wires of another speaker cable or any metal parts of the
product. Doing so may damage the product and/or the
speakers.