User Manual
Table Of Contents
- TABLE OF CONTENTS
- BEFORE USE
- NAMES OF PARTS AND THEIR FUNCTIONS
- PREPARATION
- PLAYBACK
- Basic operations
- Adjusting the sound to your preference
- Listening to TV audio
- Listening to the radio
- Playing via a Bluetooth® connection
- Listening to music via AirPlay
- Listening to internet radio
- Listening to streaming services
- Playing songs on media servers (PC/NAS)
- Playing audio from your computer (USB DAC)
- Option menu (settings for each input source)
- Basic operation of the Option menu
- List of Option menu
- Correcting volume difference between input sources
- Displaying audio signal information
- Setting the reception mode (stereo/mono) for FM radio
- Performing an initial scan for DAB radio reception
- Checking reception strength of each DAB channel label
- Setting volume interlock with this product when playing an AirPlay/Bluetooth device
- Setting auto playback
- Setting repeat playback
- Setting shuffle playback
- Improving intermittently disrupted sound from digital audio inputs
- USEFUL FUNCTIONS
- SETTINGS
- UPDATING
- TROUBLESHOOTING
- If you think there is a problem
- If you think there is a problem, the 1st step is checking the following
- Power, system, and/or remote control problems
- Problems with the audio
- Problems with TV (HDMI) connections
- Problems with FM radio
- Problems with DAB radio
- Problems with USB DAC
- Network problems
- Problems with Bluetooth
- Errors shown on the front display
- If you think there is a problem
- APPENDIX
Error and warning messages
When error or warning messages are displayed, resolve the cause based on the following table and measure
again.
[Search tag]#Q01 YPAO Error and Warning
n
Error Messages
Error Messages Solution
E-1:Noisy
Measure again after making the room quiet.
E-2:No Signal
Plug the YPAO microphone securely into the YPAO MIC jack and measure again.
If this error occurs frequently, contact the outlet where you bought this
product, or the authorized Yamaha service center.
E-3:No MIC
Plug the YPAO microphone securely into the YPAO MIC jack and measure again.
E-4:User Cancel
Depending on your purpose, measure again or close YPAO.
E-5:Headphone pluged
Unplug the headphones and then measure again.
E-10:Internal Err.
After finishing YPAO, turn this product OFF and back ON. If this error occurs
frequently, contact the outlet where you bought this product, or the authorized
Yamaha service center.
E-20:No Speakers
Select the speakers to use (A, B, A+B or Off) and then measure again. If the same
error message appears again, exit YPAO, turn OFF this product, and check the
speaker and/or PRE OUT jack connections. If using an external amp, check its
connections and power.
E-21:Control Knob
Make sure the controls on the front panel, BASS, TREBLE, BALANCE and
LOUDNESS, are in the center or FLAT positions, and then measure again.
E-22:Pure Direct
Turn PURE DIRECT on the front panel OFF (indicator not lit) and then measure
again.
NOTE
(
To exit YPAO in order to resolve the cause, press the ENTER key and then use the cursor keys (q/w) to select “Cancel” and press
the ENTER key.
(
To measure again, press the ENTER key and then use the cursor keys (q/w) to select “Retry” and press the ENTER key.
n
Warning Messages
Even when a warning message is displayed, the measurement results can still be saved. However, to get the
best speaker settings, we recommend resolving the cause and running the measurements again.
46
PREPARATION > Automatic adjustment of speaker settings (YPAO)