User Manual
Table Of Contents
- TABLE OF CONTENTS
- BEFORE USE
- NAMES OF PARTS AND THEIR FUNCTIONS
- PREPARATION
- PLAYBACK
- Basic operations
- Adjusting the sound to your preference
- Listening to TV audio
- Listening to the radio
- Playing via a Bluetooth® connection
- Listening to music via AirPlay
- Listening to internet radio
- Listening to streaming services
- Playing songs on media servers (PC/NAS)
- Playing audio from your computer (USB DAC)
- Option menu (settings for each input source)
- Basic operation of the Option menu
- List of Option menu
- Correcting volume difference between input sources
- Displaying audio signal information
- Setting the reception mode (stereo/mono) for FM radio
- Performing an initial scan for DAB radio reception
- Checking reception strength of each DAB channel label
- Setting volume interlock with this product when playing an AirPlay/Bluetooth device
- Setting auto playback
- Setting repeat playback
- Setting shuffle playback
- Improving intermittently disrupted sound from digital audio inputs
- USEFUL FUNCTIONS
- SETTINGS
- UPDATING
- TROUBLESHOOTING
- If you think there is a problem
- If you think there is a problem, the 1st step is checking the following
- Power, system, and/or remote control problems
- Problems with the audio
- Problems with TV (HDMI) connections
- Problems with FM radio
- Problems with DAB radio
- Problems with USB DAC
- Network problems
- Problems with Bluetooth
- Errors shown on the front display
- If you think there is a problem
- APPENDIX
Making bi-wiring connections
Bi-wiring allows output to the speaker woofers (low frequency) and the tweeter/mid-range (mid to high-
frequency) to be split and driven separately. Speakers compatible with bi-wiring are required for these
connections.
1 Remove the short bar or bridge attached to the jacks of the speakers.
2 Connect the product and the speakers as illustrated.
The illustration shows connecting the left channel. Connect the right channel in the same way.
Swapping the connections between speaker jacks A and B is OK.
SPEAKERS L CH
A
B
Rear panel
Speaker
NOTE
(
When the speakers have been bi-wired, it is necessary after turning the product ON to change the speaker setting to A+B before
running YPAO.
(
Use speakers with an impedance of at least 4 Ω and that are compatible with bi-wiring connections.
Related links
(
“Running YPAO”(p.42)
(
“Selecting the output speakers”(p.50)
30
PREPARATION > Connecting speakers