MUSIC SEQUENCER MIDI DATA FORMAT
(3) TRANSMIT/RECEIVE DATA Tone Generator Section (3-1) CHANNEL VOICE MESSAGES (1) TRANSMIT FLOW (3-1-1) NOTE OFF SW1 NOTE ON/OFF 9nH ACTIVE SENSING FEH SW1 > MIDI OUT STATUS NOTE NUMBER VELOCITY * Reception is always “omni on” in the record mode. The MIDI transmit channels are fixed for each track: tracks 1 … 4, C1, C2, and Bass transmit on MIDI channels 1 through 7, respectively, while the Drum track transmits on channel 10.
(3-1-4) PROGRAM CHANGE STATUS PROGRAM NUMBER 1100nnnn 0ppppppp When n = 9 in the play mode or when the record track is set to Dr in the record mode. (CnH) n=0~15 VOICE CHANNEL NUMBER p=0~127 Only data relating to voice changes is received. * Only n = 0 … 6 and 9 are shown on the display. * Reception is always “omni on” in the record mode. (Reception) * When the Utility mode PGC MODE parameter is set to NORMAL. When n ≠ 9 in the play mode or when the record track is not set to Dr in the record mode.
(3-3) REGISTERED PARAMETER NUMBER (3-5) SYSTEM EXCLUSIVE MESSAGE (3-3-1) PITCH BEND SENSITIVITY (3-5-1) GENERAL MIDI MODE ON RPN MSB RPN LSB DATA ENTRY MSB DATA ENTRY LSB Sets the Utility mode PGC MODE parameter to GM. 00H 00H mmH --- The following controllers are reset to the values shown. mmH = 00H - 18H (0 - 24 semitones) don’t care * Set to 2 semitones at power-on.
(2) RECEIVE FLOW Sequencer Section NOTE OFF 8nH (1) TRANSMIT FLOW < MIDI IN SW1 NOTE ON/OFF 9nH CONTROL CHANGE PROGRAM CHANGE PITCH BEND CHANGE BnH CnH EnH TIMING CLOCK F8H START CONTINUE STOP FAH FBH FCH SONG POSITION POINTER F2H SW1 NOTE ON/OFF 9nH CONTROL CHANGE PROGRAM CHANGE PITCH BEND CHANGE BnH CnH EnH TIMING CLOCK START CONTINUE STOP F8H FAH FBH FCH SONG POSITION POINTER F2H > MIDI OUT SW2 SW2 SW4 SW3 F0H F0H F0H F0H F0H F0H SW1 43H 43H 43H 43H 43H 43H 0nH 0nH 0nH 0nH
