Owner`s manual

Channel Job

Reference Manual

4 SEND PARAMETER field

If you have turned on the MIX ON, MIX SEND, MATRIX ON, or MATRIX send buttons

in the LINK PARAMETER field, use the buttons in this field to specify the send-destination

bus(es).

NOTE

If nothing is selected in the SEND PARAMETER field, send on/off and send level will not be

linked.

 Channel link operations

• Linking three or more channels

Hold down the link-source [SEL] key and successively press the [SEL] key of each channel

you want to add to the link group.

• Adding a new channel to an existing link group

Hold down any [SEL] key within the group and press the [SEL] key that you want to add

to the group.

NOTE

If the link-destination channel is already assigned to another link group, its assignment to the

previous group will be canceled, and it will be added to the newly assigned group.

• Removing a channel from a link group

Hold down any [SEL] key in the same link group, and press the [SEL] key for the channel

that you want to remove.

• Changing the level balance between channels that belong to the same link group

While pressing and holding down the [SEL] key for the desired linked channel, adjust the

parameter value. You can also remove all linked channels from the same link group

temporarily. This can be helpful if you want to edit parameters that are linked to each

other while maintaining the same relative level differences. For example, this may be the

case for parameters such as the HA analog gain and fader. While you are holding down

the [SEL] key, the HA analog gain and fader values will not be linked. (However, you

cannot temporarily cancel this link during the “fading” phase of a recalled scene.)

CH LINK SET window

Displayed when you press the channel display field in the CH LINK MODE window. You can

also link channels in this window.

1 Channel select button

Select a channel that you want to link. The selected channel will be indicated in blue,

and the alphabetical character that indicates the link group will appear for linked

channels.

2 LINK buttons

Link the channel selected in

3 UNLINK button

Cancels the link selected in 1.

4 UNSELECT ALL

De-selects all selected channels currently appearing in blue.

MIX1–16 MIX buses 1–16

MTRX 1–8 MATRIX buses 1–8

2 3 5 4

When selecting a channel When linking channels