Operation Manual

70 - English English - 71
19
INSTRUMENT AND CONTROL FUNCTIONS
7. Press the function select switch, and the distance (km
or mile) and speed (km/h or MPH) will begin to flash.
8. Use the assist mode switches (up & down) to switch
between “km & km/h” and “mile & MPH”.
9. Press the power switch. The settings are saved and
this function is exited.
2 Diagnosis mode
The e-Bike Systems are equipped with a diagnosis mode.
When you turn on the power, if there is a malfunction or
fault in the e-Bike Systems, the systems notify you of the
fault by flashing the assist mode indicator and the battery
capacity indicator alternately, and displaying “Er” in the
speedometer. See “TROUBLESHOOTING” regarding
symptoms and remedies for abnormal displays and abnor-
mal flashing.
If a fault is displayed, have your bicycle inspected by
a dealer as soon as possible.
20
INSTRUMENT AND CONTROL FUNCTIONS
2 Power supply to external devices
Power can be supplied to most external devices (e.g. vari-
ous smart phones etc.) by connecting a commercial USB
cable.
[To supply power]
1. Open the USB receptacle cap of the switch.
2. Connect the USB cable to the switch and external de-
vice.
3. Turn on the power of the vehicle.
[To stop the power supply]
1. Turn off the power of the vehicle.
2. Disconnect the USB cable and put on the cap of the
USB receptacle.
• Do not apply unreasonable force on the USB plug
or pull the USB cable.
• Check that the USB plug is facing the right way and
not totally out-of-position with the USB receptacle
or slanted, and make sure it is fully inserted all the
way in.
• Do not connect the USB receptacle and the USB
plug in a wet state.
• Use a USB cable that conforms to the standards.
• Do not insert foreign objects into the USB recepta-
cle unit.
Otherwise the display unit and external device may
malfunction.
TIP
• Power is supplied automatically when an external de-
vice is connected with the USB cable.
• No power is supplied if the remaining capacity of the
battery pack is low.
• The power supply of the vehicle will go off and power
supplied by the USB connection will also stop if the ve-
hicle is not operated for 5 minutes.