Operation Manual

BATTERY PACK AND CHARGING PROCEDURE

TIP

• Charging will start automatically.

• If the display unit is turned on while the battery pack is

charging, all normal displays will be shown, including

the battery capacity indicator, but the assist system will

not function.

• When the battery pack is connected to the battery

charger, battery charger lamp will flash at approximate-

ly 0.2 second intervals to indicate that charging is pre-

paring to charge the battery pack. Leave it as it is and

charging will start normally.

[CHARGING THE BATTERY PACK REMOVED FROM

THE BICYCLE]

1. Turn the display unit off.

2. Insert the key into the battery lock, and turn it to re-

lease the battery lock.

3. Remove the battery pack.

WARNING

Use both hands when removing the battery pack, be-

ing careful not to drop it. Dropping the battery pack

on your foot could result in injury.

4. Connect the power plug of the battery charger to a

household power outlet.

5. Remove the cap from the charging connector on the

battery pack, and connect it to the charging plug on the

battery charger.

NOTICE

• Do not connect the charging plug of the battery

charger with the charging connector of the battery

in a wet state.

• Be sure to connect the charging plug only after the

charging connector on the battery pack is com-

pletely dry.

Otherwise the battery charger and battery may mal-

function.

• Do not apply excessive force to the charging plug

or pull on the cord with the charging plug connect-

ed to the battery.

Otherwise, the plug or connector may be damaged.