Operation Manual

18
INSTRUMENT AND CONTROL FUNCTIONS
2 Pushing assist
When you are on or off the bicycle and start moving it, you
can use pushing assist without pedaling the bicycle.
To use pushing assist, press and hold the pushing assist
switch.
Pushing assist will stop in the following situations:
• When you release the pushing assist switch.
• If you press another switch at the same time.
• When you start to pedal.
• If your bicycle speed exceeds 6 km/h.
• If you select Off mode.
• If the wheels are not turning (when braking or coming
into contact with an obstacle, etc.).
TIP
The maximum speed will vary depending on the selected
gear. The maximum speed will become slower in a lower
gear.
2 Clock and km/mile settings
Use the following steps to set the time and km/mile settings.
1. Make sure that the display is mounted on the display
holder, and that the display unit is turned off.
2. Press the power switch while holding the function se-
lect switch.
3. When the “hour” on the clock begins to flash, release
the switches.
4. Use the assist mode switches (up & down) to set the
“hour”.