User Manual

ManualsBrandsYamaha Manualsbaby & childrenPSR-S970

121

122

123

124

125

126

127

128

129

130

124 PSR-S970/S770 Reference Manual

Connections

By using a USB wireless LAN adaptor (sold separately), you can connect the PSR-S970/S770 with an

iPhone/iPad via a wireless network. For general operating instructions, refer to the “iPhone/iPad Connection

Manual” on the website. This section covers only operations that are specific to the PSR-S970/S770.

Before starting operations, make sure that the USB wireless LAN adaptor is connected to the [USB TO

DEVICE] terminal and call up the setup display via [FUNCTION]

 TAB [F] MENU 2  [H] WIRELESS

LAN.

NOTE If the USB wireless LAN adaptor is not recognized by the instrument, “WIRELESS LAN” for the [H] button is not shown. When “WIRELESS LAN” is not

shown even though a USB wireless LAN adaptor has been connected, turn the instrument off then on again.

Infrastructure Mode

Connecting with an iPhone/iPad via Wireless LAN

[A]/[B] Selects the network.

[G] UPDATE Updates the network list on the display.

[I] DETAIL For setting the detailed parameters on the pages below. After making these

settings, press one of the [7 ]/[8 ] (SAVE) button to actually save

them.

IP ADDRESS: Sets the IP address and other related parameters.

OTHERS: When the instrument is connected to the network with the

Infrastructure Mode, the current time is shown on the Main display.

You can set the Time Zone via the [B] button and Daylight Saving

Time via the [C] button for your local time.

If you want to enter the host name, press the [A] button.

[1 ]/

[2 ]

WPS Connects this instrument to the network via WPS. Press this button fol-

lowed by the [G] (YES) button, then press the WPS button on your access

point within two minutes.

[3 ]/

[4 ]

MODE Switches to the Access Point Mode.

[5 ]/

[6 ]

INITIALIZE Initializes the connection setup to the default factory status.

[7 ]/

[8 ]

CONNECT Connects to the selected network.

If you select “Other” by using the [A]/[B] buttons, this calls up the Man-

ual Setup display in which you set the SSID, security method, and pass-

word. After entering those, press one of the [7 ]/[8 ] buttons in

the Manual Setup display to connect to the network.