User Manual

PSR-E360 Owner’s Manual

Reference

Recording Your Performance (Phrase Recording)

You can record your performance as a User Song (Song number 113), which can then be played back on the instrument. The

recorded User Song can be played back in the same way as the preset Songs.

Select the desired Voice.

Apply sustain (pages16, 31) or effect (page 16) to the sound as desired

before starting recording.

Press the [PHRASE REC] button to enable the Record mode.

"UserSong" appears on the display.

To exit from the Record mode, press the [PHRASE REC] button again. (The

display stops flashing.)

Play the keyboard to start recording.

Press the [>/] (Start/Stop) button to stop recording.

To play back the recorded Song, press the [>/] button.

• A total of approximately 300 notes can be recorded to the User Song.

NOTE

• If the User Song is recorded, the data will be recorded over and erased (you will record

over and erase previous data in “User Song”).

UserSong

001

Flashes

NOTICE

• Never attempt to turn the power off or connect or disconnect the AC adaptor. Doing so

can result in a loss of data.

• When recording capacity becomes full during recording, a “Mem Full” message appears

on the display, recording is stopped, and the Song select display is shown.

• If you press the [>/

] button, even if you don’t play the keyboard, recording starts.

Limitations while recording:

• The following settings/operations cannot be recorded: Reverb Level, Style,

playback sound on the connected external audio device, metronome click,

Transpose, Tuning.

• The following settings and buttons are not available, or if operated, the new set-

tings cannot be recorded:

Split Point, Reverb Type, Chorus Type, [FUNCTION] button, [PORTABLE

GRAND] button.

• If you make a mistake or want to erase an existing Song, you can delete the User Song. To

do this, enable the Record mode in step 2, and then press the [>/

] button twice in suc-

cession (without playing the keyboard).

NOTICE

NOTE