User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
90
“One Input to All Outputs” window
One input channel and the send levels from the input channel to all output buses are
displayed.
This window opens when you click the [One Input to All Outputs] window open button of the
“Delay Matrix” component editor or the “Matrix Mixer” component editor. Here we explain
using a screenshot of the “Delay Matrix - One Input to All Outputs” window.
a Meter
Shows the signal level for each output channel.
If there are many channels, a scroll bar will be displayed at the bottom.
b [ON] button
Switches the send from the input channel to each output bus either on or off.
c Delay Time knob (“Delay Matrix” only)
Specifies the delay time from the input channel to each output bus. You can select the
units in the Type list box.
d Type list box (“Delay Matrix” only)
The delay time specified by the Delay Time knob is converted into the units you select.
• ms...............Milliseconds
• sample.......Number of samples (The range will depend on the sampling frequency
setting.)
• meter..........Meters/second
• feet.............Feet/second