User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
65
Notch FBS
■ “Notch FBS” component editor
FIXED
After the speakers and mics have been installed, and while the DME7 settings are being
made, this method proactively finds feedback points in the current sound system, and
applies the appropriate filters. This is effective for mics whose position is fixed.
a
FIXED [ON] button
Switches the detection result between enabled and disabled.
b [DETECT] button
Starts or stops detection. This is available only when online. Detection does not end
automatically. During detection, the DYNAMIC filtering is disabled. For details on the
detection procedure, refer to Performing FBS detection for the FIXED type.
c [CLEAR] button
Clears the filter settings.
d [Freq.]
Displays the frequencies of the filters that were applied. Up to seven filters will be applied.
DYNAMIC
This method continually finds the changing feedback points while the DME7 unit is in use,
and updates the filter settings accordingly. This is effective for wireless mics whose
location is not fixed, and which can be used in a variety of positions.
e
DYNAMIC [ON] button
Enables or disables the DYNAMIC function. FBS operation will begin when you turn this
on.
f [CLEAR] button
Clears the filter settings.