User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
55
b [Type] list
Enables you to select an effect type.
c Reverb Time
Duration of time until the reverberation attenuates and stops. Higher values extend the
reverberation.
d Initial Delay
Duration of time between sound input and the start of reverberation. Higher values delay
the start of reverberation.
e Decay
Shape of reverberation envelope. Reverberation characteristics are determined by the
value.
f Room Size
Size of space. Higher values simulate larger spaces. This value is linked with the Reverb
Time value. When you change this value, the Reverb Time value changes.
g Diffusion
Density and spread of reverberation. Higher values increase the density and enhance the
spread.
h HPF
This filter cuts the low frequency range of the reverberation. The range below the
frequency specified by this value is cut. This filter does not affect the original source
sound.
i LPF
This filter cuts the high frequency range of the reverberation. The range above the
frequency specified by this value is cut. This filter does not affect the original source
sound.
j Hi Ratio
Length of reverberation in the high frequency range. The reverberation duration of the
high frequency range is expressed as a ratio relative to Reverb Time.
k Low Ratio
Length of reverberation in the low frequency range. The reverberation duration of the low
frequency range is expressed as a ratio relative to Reverb Time.
l Low Freq
Frequency value that serves as the basis for the Lo Ratio value. The frequency band
below this value is affected by the Lo Ratio parameter setting.
m Filter frequency response curve
The curve changes depending on the HPF and LPF values.