User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
42
a Comp260 [ON] button
Switches between enabling or disabling the Comp260 function.
b Compressor curve
This shows the effect as a graph. The horizontal axis is the input signal level, and the
vertical axis is the output signal level.
c [GR] meter
Indicates the amount of gain reduction.
d [KEY IN] list box
From this list, select the input signal that is used as the key-in signal; that is, the reference
signal that causes the compressor to operate.
The following choices are provided.
• [Self]
For a monaural channel component, the input signal is used as the trigger source.
• [L]
For a stereo channel component, the L input signal is used as the trigger source.
• [R]
For a stereo channel component, the R input signal is used as the trigger source.
• [KeyIn]
The key-in input is used as the trigger source.
• [Max In]
This sets the signal with the largest value in a stereo channel or a multi-channel
component as the trigger source.
• 1–64
This sets the specified channel signal in a multi-channel component as the trigger
source.
e [THRESHOLD] knob
Specifies the threshold level at which the Comp260 will take effect.