User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
35
Delay
In a sound system that includes multiple speaker units, it may appear to a listener that the
voice of the person talking is originating from a nearby speaker unit, rather than from the
actual person. In such cases, you can correct the perceived localization by delaying the audio
of the nearby speaker unit in proportion to the distance between the speaker unit near the
person who is talking and the speaker unit that is far from that person.
If sound from different speaker units is mutually interfering, adding a slight delay to one of
the audio signals will shift the interfering frequencies, lessening the unnatural sensation.
When placing this in the design sheet, select either Mono, Stereo or Multi. The illustrations
used in the following explanation are for the case of Stereo.
Audio
■ ”Delay” component editor
Here you can specify the amount of delay in terms of time or distance.
a
Delay [ON] button
Switches the delay function between enabled and disabled.
b
Delay Time knob
Specifies the delay time.
c Type list box
The delay time specified by the Delay Time knob is converted into the units you select,
and shown at the left.