User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
16
a
ANC [ON] button
Switches the ANC function between enabled and disabled.
b AMIBIENT
• Level meter
Shows the level of ambient noise.
• [THRESHOLD] knob
Specifies the average level of ambient noise. If the level of ambient noise exceeds this
value, the level of the program source is raised; if the level is lower than this value, the
level of the program source is lowered.
c GAP
• [THRESHOLD] knob
Specifies the threshold value of the program source.
If the level of the program source remains below the threshold for a specified time, it
will be interpreted as a gap.
• [TIME] knob
Specifies the time required for a gap to be detected.
d PROGRAM SOURCE GAIN
• [MIN GAIN] knob
Specifies the minimum value of program source level compensation.
• [MAX GAIN] knob
Specifies the maximum value of program source level compensation.
• [GAIN RATIO] knob
Specifies the ratio of program source level compensation. This is specified as the ratio
“Program source compensation amount”: “Amount of ambient noise increase from
the threshold value.”
• [RESPONSE TIME] knob
Specifies the response speed for level compensation.
• Level meter
Indicates the output level of the program source after compensation.
Control
Parameter types of the input/output values for each Port
Input Value
Control Parameter Output Value
Type Range
Input Port Name Parameter Range
Output Port Name Type Range
Value Num 0,1
●
On OFF:0, ON:1
●
On Value Num 0,1